DISPERSION OF GAS AND LIQUID IN BUBBLE COLUMNS OF HOMOGENEOUS BUBBLE FLOW REGIME

Mean gas holdup, lateral distribution of gas holdup and axial mixing of gas and liquid were measured in bubble columns of 12 and 19cm i.d. The lateral distribution of gas holdup was strongly dependent on the flow regimes in the column. The axial mixing of liquid in the homogeneous bubble flow regime was much smaller than that in the heterogeneous bubble flow regime, and was not expressed by existing correlations. The axial mixing of liquid in the homogeneous bubble flow and the intermediate flow regime was simulated with a flow model based on the lateral distribution of buoyancy force and the effective viscosity. The axial mixing of gas was larger than that of liquid.     

Quantitative determination of corrosion products and adsorbed water on copper in humid air containing SO2 by IR-RAS measurements

The time dependency of the amounts of corrosion products and co-existing adsorbed water on copper in humid air containing SO₂ was estimated from a series of in situ time-resolved IR-RAS spectra on the basis of the relations between the band intensities and the mass changes of the corrosion products, which were determined by simultaneous measurement of IR-RAS and QCM. The amounts of both corrosion products increased slowly at the initial stage and later increased rapidly. Although the relative humidity was kept constant, the amount of adsorbed water increased nearly the same behavior as that of corrosion products in the stage of relatively small amounts of corrosion products and later increased rapidly when the amounts of corrosion products increased. In humid air without SO₂, sulfite gradually decomposed and some of it changed into sulfate.     

Penetration treatment of plasma-sprayed ZrO2 coating by liquid Mn alloys

The penetration phenomena of liquid manganese (Mn) alloy into porous ZrO₂ (8 vvt % Y₂O₃) coating plasma sprayed on SS400 steel substrate was studied by heating in a vacuum atmosphere. The improvement in mechanical properties of the coating by heat treatment with liquid Mn alloys was examined. Liquid Mn alloys, such as Mn-Cu, Mn-Sn, and Mn-In, rapidly penetrated the coating and formed a chemical bond between the coating and the substrate. The densification of the ZrO₂ coating occurred when ZrO₂ particles were sintered with liquid Mn alloys that penetrated the porous coating. The dense coating was free of porosity, and its hardness increased after heat treatment with Mn alloys, compared with assprayed ZrO₂ coating. Moreover, the fracture toughness of the coating reached the same levels as those of sintered yttria-stabilized PSZ.     

Repeatedly foldable AMOLED display

In this study, a 5.9‐inch foldable active‐matrix organic light emitting diode (AMOLED) display was developed. A folding test was performed repeatedly. The display survived the folding test (100,000 folds) with a curvature radius of 2 mm. To protect an organic light emitting diode (OLED) against moisture, inorganic passivation layers are provided on the upper and lower sides of the flexible display. Using our transfer technology, high density passivation layers can be obtained. The measured water vapor transmission rate of the layer is 7 × 10^?6 g/m²?day or less, which improves OLED reliability. With these techniques, we have developed a book‐type display, which is repeatedly foldable like a book, and a tri‐fold display including a display area, which is foldable in three.     

Scattering mechanism and reduction of insertion losses in a laminated polarization splitter

We experimentally found the unexpected phenomena of scattering in laminated polarization splitters (LPS's) composed of a-Si:H-SiO(2) multilayer and studied its mechanism. The scattering phenomena strongly depend on the incident angle and polarization of the incident light. To reduce the scattering loss in LPS's, a multilayer with flat layer boundaries is fabricated with rf bias sputtering. As a result, the insertion loss of the LPS is reduced to ~ 1 × 10(-3) dB/ μm, which is acceptable for practical uses.     

Theoretical analysis of the spatial phase-matching loci for second-harmonic generation and multiwave-mixing interactions

We report a theoretical analysis on spatial noncolinear phase matching of multiwave mixing and its application to a second-harmonic-generation (SHG) experiment. From the numeric calculations, the noncolinear phase-matching properties in general situations were determined. The theory gives the applicability for all noncolinear phase matching. Fine coincidences between theoretical calculations and observed spatial loci on noncollinear phase-matching SHG were confirmed. Relations that allow the calculation of the noncollinear phase-matching angle for any case of SHG are established. As an example, the noncolinear phase-matched SHG pattern on a screen is calculated numerically in the case of SHG of 1064 nm from a Nd:YAG laser under the phase-matched condition for two organic nonlinear crystals: 1-(2-thienyl)-3-(4-methyphenyl) propene-1 (TC-28), which is biaxial, and (2-furyl) methacrylic anhydride (FMA), which is uniaxial. Experimental results compared quite favorably with the theoretical analysis. Noncolinear phase matching may be of great practical interest in optical multiwave-mixing processes, such as optical parametric oscillation and optical parametric amplification. This technique also can be used for the measurement of crystal optical constants.     

Threshold for Millimeter-Wave (60 GHz)-Induced Ocular Injury

Journal of Infrared, Millimeter, and Terahertz Waves - Millimeter waves (MMW) absorbed by skin or cornea may induce damage by heat. We have developed a 60 GHz MMW exposure-induced eye...     

Delignification kinetics of empty fruit bunch (EFB): a sustainable and green pretreatment approach using malic acid-based solvents

Recently, the development of efficient and environmentally benign solvents has received great attention to replace current harsh organic solvents. In this context, low-transition-temperature mixtures (LTTMs) have emerged as favorable green solvents for biomass delignification. Palm oil biomass, empty fruit bunch (EFB) was pretreated with commercial l-malic acid and microwave hydrothermally extracted cactus malic acid-derived LTTMs at 60, 80, and 100 °C. The LTTMs applied in this study were derived from malic acid–choline chloride–water and malic acid–monosodium glutamate–water with a molar ratio of 2:4:2 and 3:1:5, respectively. Three first-order reactions were used to express the delignification kinetic model of EFB. The first term was based on the initial stage and assigned as infinite due to the fast rate of delignification which could not be detected. The second and third terms were proportional to bulk and residual delignification stages. A good agreement was obtained between the kinetic model and the experimental data obtained in this study with R²?≥?0.91. The activation energies for the delignification reactions using l-malic acid and cactus malic acid-based LTTMs in the bulk and residual stages were approximated as 36–56 and 19–26 kJ/mol and 34–90 and 47–87 kJ/mol, respectively.     

Apolipoprotein A-I mutations and low high density lipoproteinemia

Urinary catecholamines (CAs) and their metabolites are usually measured during the process of diagnosing pheochromocytoma (pheo), but a 24-hour urine collection is not convenient for outpatients. Since 1987 we have utilized "spot" urine metanephrine (MN) and normetanephrine (NMN) assays for management of patients with pheo or adrenal incidentaloma. MN and NMN were measured by radioimmunoassay in 82 patients with surgically proved pheo and 15 patients with incidentaloma. In 10 patients with pheo, MN and NMN were measured with fractional every-3-hour urine samples, which were accumulated and then measured as a 24-hour urinary specimen. Fractions of 3-hour MN and NMN excretion were constant (MN 98.5 +/- 9.6%, NMN 97.6 +/- 10.8%; 24-hour MN and NMN 100%). The average levels of MN and NMN in patients with pheo were 6801 ng/mg creatinine (Cr) (range 93-88,248, median 1426) and 5627 ng/mg Cr (range 219-31,528, mean 3190), whereas the MN and NMN levels in patients with incidentaloma were 123 ng/mg Cr (range 36-246, mean 133) and 251 ng/mg Cr (range 84-472, mean 220), respectively. When we selected a cutoff value for MN + NMN of 1000 ng/mg Cr, the sensitivity was 97.6% and the specificity 100% for diagnosing pheo. When the standard was set as > 500 ng/mg Cr for either MN or NMN, both the sensitivity and specificity were 100%. The assay for MN and NMN is simple and effective, not only for screening but for diagnosing pheo and managing incidentaloma.